3
Safety instructions
When installing and using this electrical equipment, basic safety precautions should always
be followed, including the following:
○
READ THE MANUAL AND FOLLOW THE INSTRUCTIONS
○
In order to reduce the risk of injuries, children are not allowed to use the device without
strict supervision.
○
Risks of Electrical Shock . Connect only to grounding type receptacle protected by a
ground fault circuit interrupter (GFCI). Contact a qualified electrician if you cannot verify
that the receptacle is protected by GFCI.
○
Do not bury the cord . Locate cord to minimize damages caused by lawnmowers, hedge
trimmers, and other equipment.
○
In order to prevent injuries due to the running parts, do not make the electric pump
running before the pipeline has been connected.
○
To reduce the risk of electrical shock, replace damaged cords immediately.
○
To reduce the risk of electrical shock, do not use the extension cord to connect unit
electric supply; provide a properly located outlet.
○
This pump can only be used for fix-installed bath tub, it is not suitable for swimming pool
spa.
○
Do not install within an outer enclosure or beneath the skirt of a hot tub unless it has
been marked.
○
This appliance is not intended to be used by young children or infirm persons unless they
are being adequately supervised by a responsible person which can ensure their safety.
○
Young children are not allowed to play with the appliance.
○
FOR INDOOR USE ONLY.
○
KEEP THESE INSTRUCTIONS
General information
○
These are single - stage centrifugal pumps designed to operate with compact hydro
massage equipment. They are equipped with an emptying system to prevent the
discharge of residual liquid in the stoppings.
○
V/Hz esp.: See pump name plate.
○
The units are designed to operate with clean water at a maximum water temperature of
50O Celsius.
○
Storage temperature: -10O C ~ +50OC. Relative Air Humidity: 95% Max.
○
Made from top quality materials: the pumps are subjected to strict hydraulic and
electrical controls and are carefully verified.
○
Correct installation is ensured by following the instructions; Over loads may be produced
in the motor when the instructions are not being followed. We decline responsibility for
any damage caused by not following these instructions.
