1. Lay one Table Side (part H/I) on its side ensuring that the inside is facing up ❶.
2. Insert a Rubber Ring (part T) onto the threaded screw posts on both sides of the Table Top (part J) (x4), Footrest (part K) (x2) and both
Table Cross Bars (part L) (x4) ❷.
3. Insert the Table Top (part J), Footrest (part K) and both Table Cross Bars (part L) into their corresponding holes in the Table Side ❶. The
front Table Cross Bar is vertical to the ground and that the Rear Table Cross Bar is horizontal to the ground.
4. Align the other Table Side (part H/I) onto exposed threaded posts (x5) and place onto the assembly.
5. Using the Assembly Tool (part U), screw Plastic Screw Caps (part S) onto threaded posts (x5) through Table Side (part H/I) until secure ❸.
6. While holding the assembly together tightly, flip the unit over, and using the Assembly Tool (part U), screw Plastic Screw Caps (part S) onto
threaded posts (x5) through Table Side (part H/I) until secure ❸.
!
DO NOT
over tighten Plastic Screw Caps.
If using the table as an activity center, insert the four (x4) Tabletop Caps (part Q) into the openings in the tabletop to prevent items from
falling through ❹. There are two (x2) larger back and two (x2) smaller front Tabletop Caps. These can be removed and re-inserted as
needed when converting between modes.
1. Remove the Chair Rod (part F) from the Chair Base (part E). Align the Chair Back (part D) to the Chair Base forming a 90° angle and slide
the Chair Rod back through holes to connect the back to the base ❶.
2. Wrap fabric over top of the Chair Back and snap the Chair Pad (part C) into place.
3. Lay one Chair Side (part A/B) on its side with the inside facing up.
4. Insert a Rubber Ring (part T) onto the threaded screw posts on both sides of the Chair Base (part E) (x4) and both Chair Cross Bars
(part G) (x4)❷.
5. Insert the two threaded screw posts on the Chair Base (part E) into the matching holes in the Chair Side (part A/B) ❸.
6. Insert the post on the Chair Back (part D) into the matching hole on the Chair Side (part A/B) ❸.
7. Insert both Chair Cross Bars (part G) into their matching holes in the Chair Side (part A/B). The front Chair Cross Bar is vertical to the
ground and the Rear Chair Cross Bar is horizontal to the ground ❸.
8. Align the other Chair Side (part A/B) onto exposed threaded posts (x4) and place onto the assembly.
9. Using the Assembly Tool (part U), screw Plastic Screw Caps (part S) onto threaded posts (x4) through Chair Side (part A/B) until secure ❹.
10. While holding the assembly together tightly, flip the assembly over, and using the Assembly Tool (part U), screw Plastic Screw Caps
(part S) onto threaded posts (x4) through Chair Side (part A/B) until secure ❹.
!
DO NOT
over tighten Plastic Screw Caps.
CHAIR ASSEMBLY
PRODUCT ASSEMBLY
TABLE ASSEMBLY
❹
❶
F
E
D
❷
❸
G
G
A
❷
❸
❶
H
J
L
L
K
❹
Q
4
