Installing the bezel
2. Install the chassis to the fixed slides by pulling the release button in the inner member to release the
lock and allow the chassis to close.
Figure 2-4: Installing chassis to fixed slides
3. Pull the blue release button in the inner member to release the lock and allow the chassis to slide into
the rack.
4. Install the bottom-most screw at the front to secure the chassis to the rack.
What to do next
Ensure that the following guidelines are met before operating the device in the rack:
• The ambient temperature around the unit (which may be higher than room temperature) is within the
limit specified for the unit.
• There is sufficient airflow around the unit.
• Electrical circuits are not overloaded; consider the nameplate rating of all the connected equipment.
• There is over-current protection.
• The equipment is properly grounded.
• No objects are placed directly on top of the unit.
Installing the bezel
Align the bezel in front of the chassis so that the Harmonic logo appears on the top left corner.
CAUTION:
The front panel is susceptible to electrostatic discharge (ESD) when the bezel
is removed. Wear the appropriate ESD protection when you remove the bezel.
NOTE:
For optimum airflow, do not obstruct the air vents on the bezel after it is installed.
17
ProStream X 2.4.x Installation Guide