Chapter 1: ContentBridge 4000 hardware
Component
Description
12. System status LED
Located on the back edge of the server board, this LED
matches the state of the System Status LED on the front
Control Panel.
13. System ID LED
Located on the back edge of the server board, this LED
matches the state of the System ID LED on the front
Control Panel. When that button is pushed, this LED
flashes blue until the button is pressed again.
14. Baseboard Management Controller
(BMC) connector
Connect for BMC access.
1 Gigabit Ethernet NIC Indicators
The onboard 1 GbE ports on the ContentBridge 4000 have two LED indicators, one for link and the other
for activity.
• When the link and activity indicators are off, the Ethernet NIC is not connected to the network.
• When the link indicator is green, the Ethernet NIC is connected to a valid link partner on the network.
• When the link indicator is amber, the Ethernet NIC is connected to a valid network link at 10/100 Mbps.
• When the activity indicator is blinking amber, network data is being sent or received.
10 Gigabit Ethernet Eth Indicator
Ethernet ports 2 and 3 on the ContentBridge 4000 have a single LED indicator.
NOTE:
During setup, the indicator does not light until you have completed the
Configuration Assistant for the ContentBridge.
State
Description
Steady on
Eth is connected to a valid network link.
Blinking
Eth is connected and data is being sent or
received.
Green
Link speed is 10 Gbps.
Yellow
Link speed is 1 Gbps.
12
