Harmonic Ellipse 3000, User Manual

Page: 93 / 403

Chapter 4 Transport Stream Configuration
© 2013 Harmonic Inc. Harmonic All rights reserved. 93 Ellipse 3000 Release 3.0, Rev. B
M-SPTS Sub-Menu/Tab
4.3 M-SPTS Sub-Menu/Tab
Use the M-SPTS menu/tab to set the Ellipse transport streams managed by the Ellipse encoding
processing for the IP interface. Use this interface to manage multiple and independent program
transport streams received on the same IP input. The information provided in this section is
divided into the following topics:
■
M-SPTS Stream Management – lists, adds and removes streams in the M-SPTS output.
■
M-SPTS Configuration Management – manages the configuration of the M-SPTS IP streams.
4.3.1 M-SPTS Stream Management
The M-SPTS menu sets the Ellipse transport streams managed by the encoder over the IP
interface. This interface can manage multiple and independent program transport streams
received on the same IP input.
The available options and menus are:
■
Transport List Menu – Lists the currently active M-SPTS streams (see 4.3.1.1 Listing Available
M-SPTS ).
■
Add Transport Menu – Enables the user to create and add an M-SPTS stream (see
4.3.1.2 Adding an M-SPTS Transport ).
■
Drop Transport Menu – Enables the user to remove (drop) an M-SPTS stream (see paragraph
4.3.1.3 Dropping an M-SPTS Transport ).
Front Panel
To access the M-SPTS menu on the Ellipse front panel:
❖
Navigate
Root > Configuration > Transport Stream > M-SPTS
.
Web Manager
To access the M-SPTS management menu using the Web Manager:
❖
Select
Transport > M-SPTS
.
M-SPTS
1 Transport List
2 Add Transport
3 Drop Transport