Chapter 2 Initial Configuration and Basic Opera-
tion
© 2013 Harmonic Inc. Harmonic All rights reserved.
36
Ellipse 3000 Release 3.0, Rev. B
Ellipse Set-Up Procedures
4. Press
F1
on the front panel to save the parameters (refer to
for configuration
save instructions).
5. Navigate
Root > Configuration > Video > Video > Encoding > PID
.
6. Configure
PID
to 450 (use the alphanumeric touch-pad on the front panel to enter the value).
7. Press
<Enter>
on the front panel to confirm and return to the Encoding menu.
8. Configure
Activation
to
Enabled
to enable the video channel.
9. Press
<Enter>
to return to the
Encoding
screen.
10. Scroll the
Encoding
screen and make sure that all other parameters are at the required
default values.
11. Press
F1
on the front panel to save the parameters.
2.2.3.3
MPEG-2 Analog New Service Configuration Set-up Procedure
This procedure uses the front panel interface. It can be equally performed using the web manager
interface. Refer to section
of this manual for detailed information
about the options provided on each front panel and the respective web manager interface.
To create a new service called
bbc1
:
1. Navigate
Root > Configuration > Transport Stream > Services > Add New
.
2. Use the
Service Name
parameter to set
bbc1
as the name of the new service (use the
alphanumeric touch-pad to enter the service name).
3. Press
<Enter>
to confirm and return to the
Add
New
menu.
4. Use the
Add
parameter to add the new service to the transport stream.
Encoding
1 Activation
Disabled
2 PID
0200
3 Codec Profile
MPEG-2 4:2:0 8-bit
4 Latency Control
Standard
5 Resolution
644 x 576
Add New
1 Service Name
First_service
2 Add
