SL600HD PINNACLE STAIR LIFT:
Install Manual
25MAR2022 | 75403 E
17
COMPLETION PROCEDURES
PINNACLE HD STAIR LIFT: SECTION 5
TIGHTEN BRACKETS
Install and fully tighten the rail bracket mounting
screws four (4) screws per bracket). For hardwood
stairs, a pilot hole should be drilled first. For
plywood or particle board stairs, care must be
taken to prevent stripping.
SET UPPER AND LOWER
TRAVEL LIMITS
1.
Test the lower travel limit by operating the lift
downward, keeping the switch pressed. The
unit should begin to decelerate about 3" from
its final resting position and stop clear of the
floor.
2.
The final stopped position can be adjusted
to accommodate the height of the user by
repositioning the limit cam located in a slot in
the rail.
3.
Use a 5/64" Allen wrench to loosen the set
screw in the limit cam. Adjust the limit cam
up or down and re-tighten the set screws.
Repeat above steps until the lift stops in the
desired position.
4.
Repeat the above steps to set the upper limit.
For safety, the footrest should be set at least
level with the upper landing.
5.
The optimum position is met when the seat
height above the floor is the same at the top
and bottom of the stairs.
TEST SAFETY STOP
SWITCHES
1.
Safety stop switches are located in both the
upward and the downward ends of the chassis
providing protection from obstructions on the
rail.
2.
Safety stop is located in the footrest providing
protection from obstructions and trapping
hazards on the stairs.
3.
A safety stop switch is part of the swivel
seat mechanism and prevents the lift from
operating when the swivel is in use.
4. Test all safety stop switches by driving the lift
down and touching the downward end of the
chassis, the lower edge of the footrest, and
the underside of the footrest in both its folded
and unfolded positions.
5.
In each of the above cases the unit should
come to an immediate halt. The LED
indicator light on the armrest control should
turn to orange and the unit should beep
intermittently.
6.
When the control switch is released, the
unit should NOT be able to be driven in the
direction that the lift initially engaged the
obstacle. Test this condition.
7.
Test to ensure that the lift can only be driven
away from the obstruction. The LED indicator
light will turn to green and stop beeping
indicating a safe operating condition.
8.
Repeat the above tests while driving the lift in
the opposite direction.
9.
If any safety condition does not function
properly, carefully review all installation
instructions, reset the "On/Off" switch and
check that the LED indicator light is green.
Repeat the above tests.
10.
If any safety stop switch fails to immediately
