Hold-Down Arm Installation
TIGHTEN
SET
SCREWS
ADJUST TO
DESIRED HEIGHT
INSTALL
HOLD
DOWN
ARM
HOLD DOWN ARM HEIGHT CAN
BE ADJUSTED SO THAT WHEELCHAIR's
ARMRESTS CLEAR ARM WHEN LOADING
ONTO A TILTED PLATFORM.
WHEN PLATFORM IS TILTED UPRIGHT,
THE ARMRESTS SHOULD BARELY CONTACT
THE BOTTOM OF THE ARM.
THE RED STAR HANDLE CAN THEN BE
TURNED TO CINCH THE WHEELCHAIR
DOWN TIGHT.
REMOVE HITCH PIN
WHILE BRACING
TILT AND TOTE
UPRIGHT
ONCE PIN IS REMOVED, THE
TILT AND TOTE CAN BE LOWERED
JUST BELOW PARALELL WITH THE
GROUND BEFORE RESTING ON
ITS MECHANICAL STOPS.
Tilt Away Feature
TO ERECT THE TILT AND TOTE BACK TO
ITS TRAVEL POSITION,SIMPLY ROTATE
UPRIGHT, AND REPLACE THE HITCH PIN.
NEVER ATTEMPT TO TRANSPORT
WITH THE TILT AND TOTE IN THE
FOLDED DOWN POSITION.
HOLD DOWN ARM HEIGHT CAN
BE ADJUSTED SO THAT WHEELCHAIR's
ARMRESTS CLEAR ARM WHEN LOAD-
ING ONTO A TILTED PLATFORM.
WHEN PLATFORM IS TILTED UPRIGHT,
THE ARMRESTS SHOULD BARELY CON-
TACT THE BOTTOM OF THE ARM.
THE RED KNOB CAN THEN BE
TURNED TO HOLD THE WHEELCHAIR
DOWN TIGHT.
Summary of Contents for AL003
Page 1: ...AL003 Tilt N Tote...
Page 8: ...AL003 Tilt N Tote...