TEC0081 20150915 P/N: 630-00065 revA
SR601 • Pinnacle 101 Stair Lift Installation
11
Pinnacle 101 Stair
INSTALLATION PROCEDURES
9.
Position the seat directly aligned over the
carriage and place onto the seat swivel post.
Depress the swivel lever until the seat is fully
engaged with the swivel post. Check the swivel
lever to test the locking mechanism. THE SYSTEM
WILL NOT FUNCTION IF PROPER ENGAGEMENT IS
NOT ACHIEVED.
[Figure 11-1]
10.
Connect the seat cable to the 8-pin connector
on the chassis.
[Figure 11-2]
11.
The armrest control is factory set for right-hand
operation. If the user prefers to operate the armrest
controls with their left hand, loosen the single
screw on the underside of each armrest and slide
each armrest upwards. Disconnect the plug on the
armrest control, switch the armrests, and reconnect
the plug. Replace armrests and tighten screws.
[Figure 11-3 & 11-4]
Figure 11-1
Figure 11-6
Figure 11-5
Figure 11-4
Figure 11-2
Figure 11-3
TIP
When the 6-pin footrest and/or the 8-pin
chair cables are connected to the chassis,
the black installation switch on the
chassis is disabled and will not function.
NOTE - If the lift is equipped with the optional key
switch on the armrest control, be sure it is in the
locked position with the key in the vertical position.
[Figure 11-5]
12.
Turn the red “ON/OFF” switch located on the
top of the chassis to the “ON” (I) position. You
should hear a single beep and the LED indicator
light on the armrest control should cycle through
a test sequence, showing red, yellow and green
respectively. If any of the system controls or safety
sensors are engaged the LED indicator light will turn
to yellow.
[Figure 11-6]
