Harman SoundCraft MPMo, User Manual

Page: 32 / 60

30 Soundcraft MFXi MPMi User Guide Issue 1210
1 POWER INDICATOR
This LED lights to show when power is connected to the console.
2 PHANTOM POWER
Many professional condenser mics need PHANTOM POWER, which is a method of sending a powering voltage
down the same wires as the mic signal. Press the switch to enable the +48V power to all of the MIC inputs.
The adjacent LED illuminates when the power is active.
WARNING: TAKE CARE when using unbalanced mics which may be damaged by the phantom power
voltage. Balanced dynamic mics can normally be used with phantom power switched on (contact
your microphone manufacturer for guidance). Mics should always be plugged in, and all output faders
set to minimum before switching the Phantom Power ON to avoid damage to external equipment.
2-TRACK
3 2-TRACK IN
These two RCA phono sockets are unbalanced Left and Right line-level inputs, used for connecting a playback
device.
4 2-TRACK LEVEL CONTROL
This adjusts the signal level from the 2-Track inputs.
5 2-TRACK TO MIX
Press this switch to route the 2-Track input signals to the MIX Left/Right bus. The level is set with the 2-Track
level control.
MONITOR SOURCE
The following two switches select the signal source(s) to be monitored.
6 MIX/SUB
Press this switch down to monitor the sub-group outputs. Release this switch to monitor the main mix
outputs.
7 2-TRACK
Press this switch to monitor the 2-Track input signal.
MONITOR OUT
8 MONITOR OUTPUT LEVEL
This control sets the signal level fed to the MONITOR LEFT & RIGHT outputs.
9 MONITOR OUTPUTS
The Monitor Outputs are on 3-pole 6.35mm (1/4”) jacks and are balanced.
10 HEADPHONES LEVEL
This control sets the level of the Headphone output.
11 HEADPHONES SOCKET
The PHONES output is a 3-pole 6.35mm (1/4”) jack, wired as a stereo output, ideally for headphones of
32
Ω
or greater. 8
Ω
headphones are not recommended.