8
Exterior 400 Range user manual
Physical installation
Warning! Read "Safety Information"
before installing the Exterior 400 Range.
Warning! The safety and suitability of lifting equipment, installation location, anchoring method,
mounting hardware and electrical installation is the responsibility of the installer. All local safety
regulations and legal requirements must be observed when installing and connecting the Exterior
400 Range. Installation must be carried out by qualified professionals only.
Contact your Martin supplier for assistance if you have any questions about how to install this
product safely.
Location and orientation
Warning! The Exterior 400 Range mounting yoke base must be securely anchored to a suitable flat
surface at any angle, pedestal or other suitable support. Ensure that the supporting structure can
bear the weight of all installed devices plus an adequate safety margin.
Important! Make sure that there will be at least 0.1 m (4 in.) of free space and unrestricted airflow around
the fixture.
Allow for service access to the front and rear of the fixture.
An Exterior 400 Range fixture can be installed outdoors. It has an IP rating of 65 and is designed to
withstand rain and other low-pressure water projections but:
• Do not expose it to high-pressure water jets from any direction
• Do not immerse it in water (or any other fluid)
• Do not install it in a location where flooding may occur.
Ensure sufficient drainage to cope with the heaviest rainfall. Make sure that water can drain away from the
installation area at least as fast as it can enter it.
Exterior 400 Range fixtures require free and unobstructed airflow around them to ensure adequate cooling:
• Do not bury the fixture or locate it in an unventilated space
• Allow at least 0.1 m (4 in.) free space around the fixture
Install the fixture at least 0.5 m (20 in.)away from any combustible materials (wood, paper, etc.) and well
away from any flammable materials.
The aluminum housing reaches temperatures up to 90° C (194° F). Restrict public access or locate the
fixture so that it cannot accidentally be touched.
Extended mounting yoke
An extended mounting yoke is available as an accessory for the
Exterior 400 Range by ordering P/N 21080030 (see Figure 1,
Exterior 400 Image Projector illustrated). This extra-long bracket
gives additional installation options. It offers a practical solution if
you cannot install a fixture at a specific tilt angle using the standard
yoke.
Figure 1: Extended mounting
yoke
