Martin® ELP CL IP User Manual
17
Fixture Setup
This section explains the fixture characteristics you can set that determine how it can be controlled
and will behave. You choose the settings using the menus available from the control panel, and
they are retained even when the fixture is powered off.
Op
tions can also be set over the DMX line using RDM from a suitable controller, see “Setting
A complete map of the control menu structure and brief explanations of their purposes can be
found
in “Control menus” on page 30. Only the most-used functions are described in this section.
Using the control menus
See drawing above.
Use the fixture’s control panel as follows:
To access the control menus, press the MENU button.
Navigate the menu structure using the ENTER, DOWN
and UP
buttons.
To select a menu option or to confirm a selection, press the ENTER button.
To return to a higher level in the menu structure without making a change, press the MENU
button.
To exit the control menus completely, press and hold the MENU button.
Control panel display
See drawing above. When you power the fixture on it resets and then shows the following data in
the control panel display:
Name of product
Temperature of LED module
DMX address currently used
DMX Channels currently occupied
The display flashes when the fixture is not receiving a valid DMX signal.
Fast focus mode
If you need to focus the fixture but there is nobody to operate the lighting console, you can quickly
turn the fixture on in “Fast Focus mode” using the control panel. Hold down the ENTER button for
5 seconds and the fixture will come on at full brightness in open white for 60 seconds, allowing you
to set the focus. After 60 seconds the fixture will return to normal operation.
MENU
ENTER
ELP CL IP
LED 25C
001
DMX RANGE 1-11
