7
3-90-70745R16_08/13
Next, install the draft control onto the ash door. Thread
the bolt through the knob and install one of the nuts. Slip
the remaining end of the bolt through the door and install
the second nut. Adjust the nut locations so that the draft
control stops open at about 3/8" from the door surface,
while still being able to close against the door.
The next step is to install the glass and trim. Start by placing
the glass frame face-down on a flat surface. Be sure the
glass itself has the gasketting installed on the shorter ends
only. The non gasketed top and bottom allow for air-wash
and secondary air. Lay the glass into the frame, Now lift
the load door off of the stove and lay it down onto the glass
frame. Secure the frame to the door using (4) Flange-head
bolts provided. While the door is still laying flat, install the
top trim onto the door with (2) Hex-head bolts.
The coil spring handles slip onto the latches and the shaker
handle. Push while turning to install.
ASSEmblY & INSTAllATION
Grates
Grate Link
Shaker Bar Weldment
Shaker Block
(welded to stove
body)
Shaker Handle Mount
- welded to shaker bar
Shaker Handle
The last step in assembly is the shaker handle. The shaker
handle is mounted on the lower left front of the insert
with the two hex-head bolts and lock-washers already in
the shaker handle mount. If you removed the grates for
installation, make sure they are installed properly. Refer
to the illustration below.
Summary of Contents for Magnafire Elite
Page 2: ......
Page 19: ...19 3 90 70745R16_08 13...
