Harman JBL GTO-1001EZ, Service Manual, Page: 4 / 28

Power Connection
1. Connect a wire (minimum 6AWG – 13.2mm 2 – for the GTO-1001EZ; minimum 8AWG – 8.4mm 2 –for the
GTO-751EZ and GTO-501EZ) directly to the battery’s positive (+) terminal.
2. Install a fuse holder for a 120A fuse (GTO-1001EZ), 80A fuse (GTO-751EZ) or 50A Fuse (GTO-501EZ) on this wire
within 18" (46cm) of the battery’s (+) terminal. Do not install the fuse in the holder at this time.
3. Route this wire to the amplifier’s location and connect it to the amplifier’s +12V terminal. Be sure to use
appropriate grommets whenever routing wires through the firewall or other sheet metal. IMPORTANT: Failure to
adequately protect the positive wire from potential damage may result in a vehicle fire.
4. When you are finished routing and connecting this wire, install the appropriate fuse in the holder you installed near
the battery. (GTO-1001EZ = 120A fuse; GTO-751EZ = 80A fuse; GTO-501EZ = 50A fuse.)
SUBWOOFER CONNECTION
Connect the subwoofer to the amplifier’s Sub (+) and (–) terminals.
-
Subwoofer
GTO
Subwoofer Amplifier
Always connect the (+) terminal on the amplifier to the (+) terminal on the subwoofer and the (–) terminal on the
amplifier to the (–) terminal on the subwoofer.
IMPORTANT: Make sure the (+) and (–) bare wires do not touch each other or the other terminal at both the amplifier
terminals and subwoofer terminals. Touching wires can cause a short circuit that can damage the amplifier.
NOTE : The minimum subwoofer impedance is 2 ohms.
CONNECTIONS
IMPORTANT: Disconnect the vehicle’s negative (–) battery terminal before beginning the installation.
If you have not already done so, remove the two end caps that cover the amplifier’s connectors as explained in
Mounting the Amplifier, above. This will provide easier access to all of the amplifier’s connectors.
AUTO TURN-ON SWITCH
No remote turn-on connection is necessary because GTO amplifiers include signal-sensing turn-on, which will turn
the amplifier on when it receives an audio signal at any of its input connectors. The amplifier will automatically turn off
approximately five minutes after the input signal ceases.
If your audio system’s source unit includes a remote turn-on wire and you would prefer to use it, the amplifier
will sense that you’ve used a remote turn-on wire and that connection will override the signal-sensing turn-on. If
necessary, you can defeat the signal-sensing turn-on circuit by moving the Auto Turn-On switch to the “Off” position.
4
GTO-1001EZ