EN
5
E. Setting the bass boost
You can apply a boost to the output at 45Hz in subwoofer mode
and in full-range mode.
Boost level
LED configuration
0dB
3dB
6dB
F. Setting the woofer phase
You can set the woofer phase to 0° or 180°, whichever provides
the cleanest bass output.
Phase
LED configuration
0°
180°
G. Using the speaker in Full-Range Mode in vehicle
To enter Full-Range Mode, press and hold the Connect button
and Play/Pause button simultaneously for 5 seconds. Repeat the
process to return to Subwoofer Mode.
The power button will turn green, the five white LEDs will flash,
and an alert will sound to indicate Full-Range Mode.
NOTE:
You can adjust input level, gain, phase, and bass boost in
Full-Range mode, as described above. (Crossover cannot be adjusted
in Full-Range Mode.)
V. RELEASING THE SPEAKER FROM
THE DOCK FOR PORTABLE USE
A. Follow these steps to remove the speaker
from the dock
1. Pull the handle at the base of the dock forward.
2. Disconnect the wire harness by gently pressing down on the
tab at the top of the plug, then pulling gently away.
3. Lift away from the dock.
B. Replacing the back-panel cover
To ensure IPx5 water-resistant performance, replace the cover on
the back panel by pressing it into place.
C. Connecting an audio device with Bluetooth
To enter pairing mode, press the Bluetooth button on the top
panel. The button will flash to indicate that it is ready for pairing.
Find JBL BassPro Go on your audio device and select it. The
Bluetooth button will remain illuminated when pairing is complete.
NOTE:
Once you have paired a device, the BassPro Go will remember it
and pair with it automatically.
You can enjoy Social Mode and pair up to two more devices by
pressing the Bluetooth button, then finding the BassPro Go in the
menus of each Bluetooth device and tapping to pair.
The BassPro Go will enter sleep mode after 10 minutes of
inactivity, and power off after 20 minutes of inactivity. Press the
power button to turn the speaker back on.
Bluetooth button color/
behavior
Mode of operation
White, flashing
Bluetooth is in pairing mode
White, solid
Bluetooth is connected
Off
Bluetooth is disconnected
D. Adjusting playback volume and selecting
play/pause when in portable use
To raise the volume when using the BassPro Go as a portable
speaker, press the Volume Up (+) button. To lower it, press the
Volume Down (–) button. To play or pause, press the Play/Pause
button.
NOTE:
You can also adjust the playback volume and play/pause using
the controls on your Bluetooth music device.
NOTE:
You can adjust the bass boost using the same steps described
in the Settings Mode section above. Increased bass boost will shorten
battery life.
E. Charging a music device with the BassPro
Go undocked
The BassPro Go lets you charge your music device with its built-in
USB port. To charge your device:
1. Remove the cover from the back panel.
2. Plug the USB power cable of your device into the USB port on
the back panel of the BassPro Go.
JBL BassPro Go_owners manual_SOP_V6.indb 5
JBL BassPro Go_owners manual_SOP_V6.indb 5
11/23/2020 5:53:02 PM
11/23/2020 5:53:02 PM
