5
510
Using The 510
To set the 510, follow these steps:
1.
Start by setting the controls as shown below.
Disengaged
Off
2.
Ensure the signal has sufficient bass content to process. While monitoring the signal, raise the
36 Hz–56 Hz
control
until the desired amount of low-end enhancement is achieved within the frequency range.
3.
Raise the
24 Hz–36 Hz
control until the desired amount of low-end enhancement and roll-off is achieved within the
frequency range.
4.
Adjust the
SUBHARMONICS
control to fine tune the amount of subharmonic processing applied to the signal.
5.
Raise the
LF BOOST
control to fill in the “gap” between the generated subharmonics and the program material’s
lower-midrange frequencies. Note that the
LF BOOST
control can be used by itself if required. To do so, simply lower
the
SUBHARMONICS
control to the MIN setting to prevent generated subharmonics from being added to the
processed signal.
6.
Use the
BYPASS
button to compare the processed and unprocessed signals to ensure the desired results have been
achieved.
