Harman Crown DSi 8M, Operation Manual, Page: 5 / 11

Operation Manual
DSi 8M Cinema System Monitor
page 8 page 9
DSi 8M Cinema System Monitor
Operation Manual
3 Installation
3.1 Materials Required
You will need to supply the following materials:
• Shielded audio cable for connecting the DSi 8M to the
cinema processor and power amplifier inputs
• Twisted wire for connecting the DSi 8M to non-DSi power-
amplifier outputs
• Four 10-32 x 1/2” screws to mount the DSi 8M in the
audio equipment rack
• Small standard screwdriver
• No. 2 Philips screwdriver
• Wire strippers
3.2 Mount the DSi 8M
The ideal place for the DSi 8M Monitor Panel is in the sound
rack or projector console between the stereo proces sor and
power amplifiers. DB25 and HD15 connectors are available
on the back panel to make installation quick and easy.
Alternatively, terminal blocks allow the use of stripped and
tinned wire. They are pluggable for easy service and
troubleshooting.
3.3 Monitor Wiring
1. Connect to AC Power.
Connect the unit to the AC power outlet using the
stan dard IEC cable provided. Any power source from
100-240V , 50-60 Hz will be sufficient. Plug the
Modular Power Supply into the Bypass Power input and
into a power source that matches the Modular Power
Supply requirements.
(continued)
L Biamp
C Biamp
R Biamp
Sw Amp
LS/RS Amp
Bsl/Bsr Amp
CINEMA PROCESSOR
MAIN AUDIO
OUTPUTS
OPTION CARD I/O
DB-25
CABLES
DSi-8M
DSi POWER AMPLIFIERS
VGA
CABLES
Figure 3.1 Wiring DSi 8M Monitor Panel to DSi Amplifiers
3 Installation (continued)
2. Connect cinema processor output to DSi 8M input.
See Figure 3-1. Use the male-female 25-pin D cable to connect the
output of the cinema processor to the Main input of the DSi 8M. If
“EX” channels are to be used, plug an additional male-female 25-pin
D cable from the
Optional Outputs at the processor to the Optional
Inputs of the DSi 8M.
3. Make DIP switch settings.
Ls/Rs in Main Connector:
Set switches 1-4 ON, 5-8 OFF.
Ls/Rs in Optional Connector: Set switches 5-8 ON, 1-4 OFF.
USL JSD-80 processor using:
Bsl/Bsr in Main Connector: Set switches A-D ON, E-O OFF.
Lc/Rc in Main Connector: Set switches A-O OFF.
Lc/Rc and/or Bsl/Bsr in Optional Connector: Set switches E-H ON,
A-D OFF, J-O OFF.
Dolby
®
CP-650 processor using:
Le/Re in Optional Connector: Set switches E-H ON, A-D OFF, J-O
OFF.
Lm/Cm/Rm in Optional Connector: Set switches J-O ON, A-H OFF.