4
Regulatory Information
An example of this equipment has been tested and found to comply with the following European
and international Standards for Electromagnetic Compatibility and Electrical Safety:
Radiated Emissions (EU):
EN55022:2006
Immunity (EU):
EN55024:1998
Electrical Safety (EU):
IEC60065-01 + AMD2
Mechanical Installation
Important User Information
Do not remove covers. No user serviceable parts inside, refer servicing to qualified service
personnel. For continued compliance with international EMC regulations, it is important that all
cables be screened, and connected as follows: Network cables should be of type Cat 5, fitted
with a clip-on ferrite sleeve (STEWART TYPE 28A2029-0A0) near the network socket end. This
equipment must be earthed. It should not be necessary to remove any protective earth or signal
cable shield connections to prevent ground loops. Any such disconnections are outside the
recommended practice of BSS Audio, and will render the EMC or safety certificate void.
If the unit is likely to undergo extreme vibration through extensive road trucking and touring,
the unit must be supported at the rear and/or sides to lessen the stress on the front mounting
flange. The necessary support can generally be bought ready-built as a rack tray, or the unit can
be mounted between other units. Damage caused by insufficient support is not covered by the
warranty. To prevent cosmetic damage to the front panel finish, use protective plastic cups under
the rack mounting bolts.
www.audiovias.com
