BDS 280/580
12
connections
Connecting the AC Power
The BDS system comes with a detachable Ac power cord. This type of cord makes it
easier for you to install and connect all other system wiring to the system’s rear panel.
NOTE:
•
The power requirement for the BDS system is 100V – 240V AC,
50/60Hz, 120W (BDS 580 system) or 90W (BDS 280 system).
•
Before connecting the AC power cord to a wall outlet, confirm that
you have correctly made all of the speaker connections, video con-
nections and audio component connections.
connect the female end of the system’s detachable power cord to the rear panel Ac
power input. plug the other end into a working, unswitched Ac outlet.
AC Power Cord
Connecting Headphones
your BDS system’s headphone connection accepts a standard 1/8-inch (3.5mm) stereo
headphone plug. When you insert the headphone plug into the connector, the system’s
speaker outputs will mute; the hDMI audio output to the Tv will not mute.
When headphones are connected to the system’s headphone jack, pressing the remote’s
Surround button cycles between these two modes:
• harman headphone, which virtualizes a multichannel surround soundtrack
down to two channels. This mode retains the soundtrack’s original
directional cues, allowing you to enjoy an enveloping surround-sound
experience on any ordinary pair of stereo headphones.
• headphone Bypass, which down mixes surround-sound programs into
normal stereo. This mode does not retain any multichannel directional cues
that may be in the original surround-sound program.
Connecting to Network through Wi-Fi
you can connect the unit to the internet through Wi-Fi.
The following instructions help you to connect your unit to the network.
• From the home screen, select
Settings > Network
.
• Make sure network connection is set to On.
• Set Type to
Wi-Fi
.
• Select your preferred method of connecting to your wireless network under
Setup Wi-Fi
.
There are five options for setting up wireless networks:
• choose a wireless network
• configure Wi-Fi by iOS
• WpS pBc (push Button control)
• WpS pIn
• custom Setup
Choosing a Wireless Network
To choose a wireless network:
1. Select
Choose a network
from the
Setup Wi-Fi
list.
2. Follow the instructions on the screen to select your wireless home
network and enter your security password, if applicable.
Configuring Wi-Fi by iOS
connect any iOS device (iphone, ipod touch or ipad) to the front panel uSB port of the
BDS. Make sure Wi-Fi is enabled on your iOS device and that it is currently connected to
your wireless home network.
NOTE: iOS version 5 or higher is required for iOS Wi-Fi sharing.
1. Select
Configure Wi-Fi by iOS
from the
Setup Wi-Fi
list.
A pop-up will be displayed on your iOS device.
2. Select
Allow
to confirm that you want to share your Wi-Fi settings.
3. The connection should now be established automatically.
check the status on your Tv for confirmation