Harman AMX NMX-WP-N1512, User Manual, Page: 25 / 34

Chapter 3: Windowing Processor Configuration Options
25
N1512 Windowing Processor User Manual
Security Page
Click the Security link at the top of any of the main web pages to access the page shown in Figure 18 . This page allows you to force
HTTPS connections and set up a password for stream encryption. To successfully display an encrypted stream, the Security
passwords much match on all devices being used (Encoders, Decoders and Windowing Processors).
NOTE: This page requires and will redirect to an HTTPS connection.
FIG. 18
Security Page
LLDP Page
Click the LLDP link at the top of any of the main web pages to access the page shown in Figure 19 . The LLDP page displays
information from the Link Layer Discovery Protocol (LLDP) packet which identifies the port number and the switch the device is
connected to. The Sys Name ID , Sys Description , Port ID , and Port Description fields all reflect the information that was entered
on the connected switch’s web interface.
FIG. 19
LLDP Page
TABLE 8
Unit Settings Page: Software Section
Option Description
Serial Displays the serial number of the Windowing Processor.
MAC Address Displays the MAC address of the network interface of the Windowing Processor.
MAC Address U0 - U3 Displays the MAC addresses of each of the four U ports on the Windowing Processor.
Web Version Displays the date code for the currently running version of the web interface.
Firmware Version Displays the date code for the currently running version of the Windowing Processor internal firmware.
Est Max Bandwidth Displays the calculated maximum bandwidth for the given output resolution and compression ratio.
Factory Restore Click to restore the device to the original factory settings. This resets everything except the IP address
(including name, stream number, etc.).
Reboot Click to reboot the device (does not affect current configuration).