Installing and Configuring Your AV Equipment
20
N2312/N2322 User Manual
Switching and Scaling Options
N-Series Encoders and Decoders make up a true AV matrix solution. In other words, one input can go to any or all outputs.
Decoders have internal scaling capabilities. Keep the following in mind:
The input of an Encoder is the video and/or audio signal going into the Encoder.
The output of an Encoder is the network stream.
The input of a Decoder is the network stream.
The output of a Decoder is the digital video and/or audio being transmitted out to the display device.
Upscaling is fully supported.
Downscaling is supported only if the input is 3840x2160 and the Decoder scaler is set to 1080p50/60. Any other attempts
at downscaling are not recommended/supported.
Seamless Switching
The N2300 Series supports seamless switching capability if the scalers in the Decoders are all set to the same resolution and
refresh rate. If the scalers are off, all of the
sources
must have the same resolution and refresh rate.
To get streams onto a Decoder, use the
Video Matrix
tab to route video from an Encoder to a Decoder. This works seamlessly if the
previously mentioned settings are true. All you have to do is click the common cell on the matrix, and click the
Take
button. See
for an example.
FIG. 16
Seamless Switching Using the Video Matrix
Enabling this cell causes the Decoder named
Conf Rm Dec
to listen
to the Encoder named
Conference Rm Encoder
.
Click
Take
to apply
changes.
