Initial Configuration
24
Instruction Manual - Massio ControlPads and Keypads
3.
Click
Search For Masters
to search the network for online Masters in the Search for Masters dialog (FIG. 29).
4.
Click
Start Searching
to begin listening for "blink" (UDP) messages from NetLinx Masters on the subnet.
5.
When you see the IP Address for the ControlPad in the List of Active NetLinx Master Controllers, click
Stop Listening
. The IP
address of the ControlPad is listed in the TCP/IP column of the dialog.
Changing the ControlPad’s Network Address Information
1.
Select
Options > Master's Network Address
to open the
Master Controller's Network Address
dialog (FIG. 30):
2.
Edit the
IP Address
fields as necessary:
FIG. 29
Search for Masters dialog
FIG. 30
Master Controller's Network Address dialog
• Host Name:
Use this field to view/edit the ControlPad’s current Host Name.
NOTE:
Host names may contain only the ASCII letters 'a' through 'z' (in a case-insensitive manner),
the digits '0' through '9', and the hyphen ('-').
• Use DHCP/
Specify IP Address:
Use these radio buttons to specify whether to use DHCP, or to Specify an IP Address for the ControlPad.
DHCP is selected by default.
NOTE:
If you select DHCP, the IP Address and Subnet Mask fields (below) are disabled for editing.
• IP Address:
Use this field to view/edit the ControlPad’s current IP Address.
• Subnet Mask:
Use this field to view/edit the ControlPad’s current Subnet Mask assignment. Click the help icon to open
the Valid Subnet Masks help topic, which lists valid subnet masks, and the maximum number of IP hosts
allowed for each.
• Gateway:
Use this field to view/edit the ControlPad’s current Gateway assignment.
• Set IP Information:
Sets the new IP information, as indicated in this dialog.
NOTE:
RPMLoader will reboot the ControlPad when the Set IP Information button is clicked.