Harman® • Accentra Owner’s Manual_R40 • 2002 -___ • 11/15
7
3-90-08326c
C. Control Explanation
Mode Selector
Allows you to choose between Room Temp Mode,
Constant Burn Mode, or OFF. Also allows you to
vary the distribution blower speed by turning the
knob to the high or low side of each mode.
Feed Limit
Sets the maximum feed
rate
Test
Runs all motors at full
speed for one minute to
check operation. After
a minute, the control
will simulate a minimum
burn and the combustion
blower will remain on
low.
Distribution Blower
speed adjustment
range.
L = low
H = high
V a r i a b l e s p e e d
anywhere between L
and H; although as the
stove temp. goes up, so
does the L and H scale.
Power Light
Indicates power to the
control.
Indicates power to
the feed motor.
Indicates power to
combustion blower
Status Light
Will be lit in either stove
or room temp mode when
pointer is not within off
position band except after
normal shut down. Blinks to
indicate errors listed below.
Indicates power to
distribution blower.
Indicates igniter is on.
Igniter switch
Set to appropriate Start-
Up mode.
Temp dial
Allows you to adjust the
room temperature in
Room Temp Mode using
the outer scale marked in
degrees Fahrenheit. It also
allows you to adjust the
stove temperature while in
Constant Burn Mode using
the inner scale marked from
1 to 7.
Dealer Diagnostic Port
For dealer maintenance
only. Requires special DDM
monitor supplied to Harman®
Dealers exclusively.
