Harman Stove Company Harman Clarity 828i, Installation And Operating Manual

Page: 10 / 24

10
ASSEmblY
Installing the Insert Into the fireplace
The Clarity Fireplace Insert has an integrated draft
hood. Therefore, a separate draft hood is not re-
quired.
Some fireplace openings may be large enough to
connect the draft hood to the venting
after
the unit
has been moved to its final position. Some openings
will be too small and will require that the draft hood
first be connected to the venting, and then guided
into position on the top of the insert as the unit is
pushed back into the fireplace.
Particularly in installations with tight clearances,
the procedure will be most easily accomplished if the
trim and wing panels are installed as the last step.
Follow these steps:
1. Connect the Clarity Insert's detachable draft
hood to the end of the venting by sliding it inside the
venting, then secure it with three sheet metal screws.
The right side trim panel installs in the same fash-
ion as the left, but the wiring (Two Amp Mate-N-
Lok connectors) that serves the On-Off switch at the
top of the panel and the blower speed control switch
on the bottom must be connected first.
Move the right panel close enough to make the
connection. Align the three wire male connector
with the latch to the bottom. Push into the three
wire female connector on the stove until it clicks.
Do the same with the two wire connector with the
latch turned to the top. Move panel into place while
routing the switch wires into the opening of the wing
bracket. Secure the panel.
8. Install the top wing cover, which is also held in
place by the magnets.
9. Install the gold wing trim by sliding the side
pieces down from the top over each clip, one at a
time.
Install the top wing panel last using two 1/4-0 fas-
teners. The mounting holes are near the inside edge
of the side wing panels. Before tightening, make sure
the outer edges of the top panel align with the edge
of the side panels. Brass edge trim is added as the
last step of installing the wing panels.
7. Mount the side trim panel, each is held in place
by two magnets. Install the left side trim panel first
by placing the bottom close to where it goes, then
align the top and move it close to the insert body
until it is held snugly by the two magnets.
. Line up the two draft hood guides with the
fourth heat exchanger tube from each side, as shown
above.
3. With assistance, push the insert back into the
fireplace, while at the same time guiding the draft
hood into position. Continue until both guides are
far enough forward that the retainer clamps and nuts
can be installed on the threaded guide bolts.
4. Tighten the nuts to secure the draft hood.
5. Adjust the rear levelling bolts until the unit is
level.
6. Install the wing panels; they attach to brackets
on each side of the Clarity. Install the side wing pan-
els first, using two 1/4-20 fasteners for each panel.
Their mounting locations are near the top and bottom
of the panel.