REAR PANEL CONNECTIONS
5
Rear Panel Connections
Optical and Coaxial Digital Outputs
FM Antenna
AM Antenna
Analog Audio Outputs
DAB Antenna
AC Power Cord
Remote Control Output
Remote Control Input
Optical and Coaxial Digital Outputs:
Connect one of these jacks to the optical or
coaxial digital input of your pre amplifier or inte-
grated amplifier, if available.
Note that these digital outputs only contain the
digital signal from the DAB stations. For FM/AM
reception, you will have to connect the analog
outputs at all times.
FM Antenna:
Connect an indoor or external
FM antenna to this terminal.
AM Antenna:
Connect the AM loop anten-
na supplied with the receiver to these terminals.
If an external AM antenna is used, make connec-
tions to the
AM
and
GND
terminals in accor-
dance with the instructions supplied with the
antenna.
Analog Audio Outputs:
Connect these
jacks to the tuner input of your pre amplifier or
integrated amplifier for analog audio playback.
Be certain to observe proper channel connec-
tions using the color-coded cables and connec-
tors so that red connects right channels and
white connects left channels.
NOTE:
Before making any audio connections,
unplug all components of your audio system
from their AC power outlets. To reduce the possi-
bility of hum or noise in your system, place all
audio interconnection cables away from both AC
power cords and speaker wires.
DAB Antenna:
Connect a DAB antenna to
this terminal.
AC Power Cord:
Connect this plug to an
AC outlet. If the outlet is controlled by a switch,
make certain that it is in the ON position.
Remote Control Output:
Connect this
jack to the infrared (IR) input jack of another
compatible Harman Kardon remote controlled
product to have the built-in Remote Sensor on
the tuner provide IR signals to other compatible
products.
Remote Control Input:
Connect the
output of a remote infrared sensor, or the
remote control output of another compatible
Harman Kardon product, to this jack. This will
enable the remote control to operate even when
the front panel Remote Sensor on the tuner is
blocked. This jack may also be used with
compatible IR remote control-based automation
systems.
