Harman Kardon HKTS 60BQ, Owner'S Manual

Page: 8 / 14

8
Connecting the Subwoofer to a Receiver or
Preamp/Processor With a Dedicated Subwoofer Output
Use this installation method for receivers and preamp/processors that have a
dedicated subwoofer output with low-pass filtering (also called bass management).
If the dedicated subwoofer output does not have low-pass filtering, follow the
instructions in
Connecting the Subwoofer to a Receiver or Preamp/Processor With
Line Outputs, on page 9.
Use the LFE (purple) connector of the supplied combination LFE and trigger
cable to connect the HKTS200SUB’s Line-Level LFE In Jack to the dedicated
subwoofer output (or LFE output) of your receiver or preamp/processor.
Connect each satellite speaker and the center speaker to the corresponding
speaker terminals on your receiver or amplifier.
Configure your receiver or preamp/processor’s setup menu for Subwoofer ON ,
and set the front left, front right, center and surround speakers to Small . After
you have made and verified all connections, plug the HKTS200SUB’s AC Power
Cord into an active AC outlet.
+ –
+ – + –
+ – + –
LEFT
SUB
LFE OUT
+ – + –
+ –
+ –
+ –
+ –
+ –
RIGHT
SURROUND FRONT CENTER
Front Left Front Right
Surround
Left
Surround
Right
Center
Subwoofer
Receiver
LFE/Trigger Cable
(Purple Ends) Surround Left
Speaker Cable
(Blue Bands)
Front Left
Speaker Cable
(White Bands)
Front Right
Speaker Cable
(Red Bands)
Center
Speaker Cable
(Green Bands)
Surround Right
Speaker Cable
(Gray Bands)
PL0004-01001
Setup Instructions
HKTS 60BQ