7
HKTS 60BQ/230
ENGLISH
Mounting Options
nOTe: If you’re running the speaker wire through the wall, you can bring it out directly
behind the bracket location and insert it through the bottom opening in the wall portion of
the bracket, as shown in the illustration. Running the wire in this way will keep the wire
completely hidden from view once the installation is complete.
Insert Wire into
Bottom Opening
Bring Wire out
through Here
If you’re not running the speaker wire through the wall, insert it through the wall
5.
portion of the bracket, as shown in the illustration.
Pass the speaker wire through the speaker portion of the wall-mount bracket, as
6.
shown in the illustration.
Bring Wire In
through Here
Bring Wire out
through Here
If you have not already removed the speaker’s base, do so by pulling it straight off
7.
the speaker, as shown in the illustration. Applying even pressure to both sides of
the base will allow it to slide off smoothly.
lift Base Straight
off Speaker
Apply Pressure evenly
to Both Sides of Base
CAUTIOn: Before making speaker connections, be sure that your receiver or amplifier is
turned OFF and its AC cord is unplugged from the AC outlet.
Connect the speaker wire to the speaker terminals as shown in the illustration:
8.
Press down on the top of the terminal to open the connection hole.
A.
Insert the wire’s bare end all the way into the hole.
B.
Release the terminal to secure the wire.
C.
Insert the conductor with the coloured band into the speaker’s red ( + ) terminal, and
insert the other conductor into the speaker’s black ( – ) terminal.
+
–
A. Push Down on Cap
to Open Hole
B. Insert Bare Wire
into Open Hole
C. Release Cap
to Secure Wire
IMPORTAnT: Make sure the ( + ) and ( – ) bare wires do not touch each other or the
other terminal. Touching wires can cause a short circuit that can damage your receiver
or amplifier.
Slide the speaker portion of the wall-mount bracket onto the speaker as shown
9.
in the illustration. Fit the grooves on the bracket onto the rails in the speaker, and
apply even pressure on both sides of the bracket so it slides straight onto the
speaker.
Push the bracket all the way onto the speaker until it snaps into place.
•
Pull any slack speaker wire back through the bracket as you slide the bracket
•
onto the speaker.
Fit Bracket grooves
onto Speaker Rails
Push Down evenly on
Both Sides of Bracket
Slide the speaker onto the bracket’s wall section, as shown in the illustration. Pull
10.
any slack speaker wire back through the bracket’s wall section.
Slide Speaker onto
Wall-Mount Bracket
Fit the metal stop plate into the recess on the bottom of the bracket with the pad
11.
facing the bracket, and fasten it to the bracket using two of the supplied screws.
Fastening it will prevent the speaker from detaching from the bracket and will hold
the speaker’s position as you rotate it.
Stop Plate
Supplied Screws
