6
TROUBLESHOOTING
TROUBLESHOOTING
SYMPTOM
SOLUTION
If there is no sound from
• Check that the receiver/amplifier is on and a source is playing.
any of the speakers:
• Check all wires and connections between receiver/amplifier and speakers. Make sure all
wires are connected. Make sure none of the speaker wires are frayed, cut or punctured, and
that no wires are touching each other.
• Review proper operation of your receiver/amplifier.
If there is no sound coming from
• Check the “Balance” control on your receiver/amplifier.
one speaker:
• Check all wires and connections between receiver/amplifier and speakers. Make sure all wires
are connected. Make sure none of the speaker wires are frayed, cut or punctured, and that
no wires are touching each other.
• In Dolby
®
Digital or DTS
®
mode, check the speaker and channel output levels and adjust if needed.
• Turn off all electronics and switch the speaker in question with one of the other speakers that
is working correctly. Turn everything back on, and determine whether the problem is in the
same place: i.e., the speaker that was working previously now has no sound and the speaker
that was not working now sounds fine; or whether it has moved: i.e., the speaker that was
not working still has no sound and the speaker that was working is still fine. If the problem is in
the same place, the source of the problem is most likely with your receiver or amplifier, and you
should consult the owner’s manual for that product for further information. If the problem has
followed the speaker, consult your dealer for further assistance or, if that is not possible,
visit our Web site at
www.harmankardon.com
for further information.
If the system plays at low volumes but • Check all wires and connections between receiver/amplifier and speakers. Make sure all wires
shuts off as volume is increased:
are connected. Make sure none of the speaker wires are frayed, cut or punctured, and
that no wires are touching each other.
• If more than one pair of main speakers is being used, check the minimum impedance
requirements of your receiver/amplifier.
If there is low (or no) bass output:
• Make sure the polarities (+ and –) of the left and right speaker inputs are connected properly.
• Consider adding a powered subwoofer to your system.
If there is no sound from the
• Check all wires and connections between receiver/amplifier and speakers. Make sure all wires
surround speakers:
are connected. Make sure none of the speaker wires are frayed, cut or punctured, and
that no wires are touching each other.
• Review proper operation of your receiver/processor and its surround sound features.
• Make sure the movie or TV show you are watching is recorded in a surround sound mode.
If it is not, check to see whether your receiver/processor has other surround modes you may use.
• In Dolby Digital or DTS mode, make sure your receiver/processor is configured so that the
surround speakers are enabled.
• Review the operation of your DVD player and the jacket of your DVD to make sure that the
DVD features the desired Dolby Digital or DTS mode, and that you have properly selected that
mode using both the DVD player’s menu and the DVD disc’s menu.
HKS 9 OM.qxd 11/3/06 9:21 AM Page 8
