Harman Kardon HK3375, Owner'S Manual

Page: 8 / 20

REAR-PANEL CONNECTIONS
8 REAR-PANEL CONNECTIONS
AC 120V 60HZ
400W
(120V, 60Hz)
IN
FM
75
Ω
AM
LOOP
IN IN IN PLAY REC. OUT PLAY REC. OUT MONO
RIGHT LEFT
SUB OUT PRE OUT MAIN IN TAPE MON. TAPE 2 AUX CD PHONO
OUT
L
R
GND
S P E A K E R 1 ( 8 O h m s )
S P E A K E R 2 ( 8 O h m s )
¢
∞
¡
™
‹
›
fi
‚
⁄
¤
ª
• §
¶
fl
‡
a
·
°
£
¡
AM Antenna
™
FM Antenna
£
Phono Ground
¢
Remote IR In
∞
Remote IR Out
§
Phono Inputs
¶
CD Inputs
•
Aux Inputs
ª
Tape Monitor Play/In
‚
Tape Monitor Record/Out
⁄
Tape 2 Play/In
¤
Tape 2 Record/Out
‹
Main In
›
Pre-Out/Main-In Jumper Pins
fi
Preamp Out
fl
Subwoofer Out
‡
Speaker 1 Terminals
°
Speaker 2 Terminals
·
Accessory Outlets
a
Power Cable
¡
AM Antenna: Connect the AM loop antenna sup-
plied with the receiver to these terminals. If an external
AM antenna is used, make connections to the
AM and
GND terminals in accordance with the instructions sup-
plied with the antenna.
™
FM Antenna: Connect an indoor or external FM
antenna to this terminal.
£
Phono Ground: Connect the ground wire from a
turntable to this terminal to reduce system hum.
¢
Remote IR In: If the HK 3375’s front-panel
IR sensor is blocked due to cabinet doors or other
obstructions, an external IR sensor may be used.
Connect the output of the sensor to this jack.
∞
Remote IR Out: This connection permits the IR
sensor in the receiver to serve other remote-controlled
devices. Connect this jack to the “IR In” jack on
Harman Kardon (or other compatible) equipment.
§
Phono Inputs: Connect the outputs of your
turntable or tonearm to these jacks. Only Moving
Magnet (MM)-type cartridges may be used.
¶
CD Inputs: Connect these jacks to the output of a
compact disc player or CD changer.
•
Aux Inputs: Connect these jacks to the line-
level output of any audio device such as a TV,
cable converter or portable audio player.
ª
Tape Monitor Play/In: Connect these jacks to
the Play/Out jacks of an audio recorder.
‚
Tape Monitor Record/Out: Connect these jacks
to the Rec/In jacks of an audio recorder.
NOTE: When these jacks are connected to a three-
head recorder or another device with off-head play-
back, it will be possible to monitor the source being
recorded.
⁄
Tape 2 Play/In: Connect these jacks to the
Play/Out jacks of a second audio recorder.
¤
Tape 2 Record/Out: Connect these jacks to the
Rec/In jacks of a second audio recorder.
‹
Main In: These jacks are the input to the HK 3375’s
power amplifier. Unless an external power amplifier is used,
the
Jumper Pins
›
should remain connected to the
Preamp Out Jacks
fi
.