4
GO + PLAY WIRELESS
HARMAN KARDON
Bluetooth
Pairing and
Technical Specifications
Listening to Audio from a Bluetooth-Capable Device
1. Press the Harman Kardon Go + Play Wireless’s “Power” button. The Status LED will illuminate white.
2. The Harman Kardon Go + Play Wireless unit will automatically enter the
Bluetooth
pairing mode.
3. Perform a new device search on your
Bluetooth
-capable device.
4. Select “GO+PLAY WIRELESS” on the device’s pairing list. If the device asks for a passcode,
enter 0000.
5. When pairing is successful the Harman Kardon Go + Play Wireless’s Status LED will change
to blue.
6. Control playback from your
Bluetooth
-capable device.
To pair with a different device, press and hold the Power button until the LED turns white, then
repeat steps 3 – 5 above.
Listening to Music from an Auxiliary Device
1. Connect the auxiliary device’s output into the “Aux in” jack by using a stereo 3.5mm (1/8"
auxiliary cable (not supplied).
2. Press the “Power” button located on top of the Harman Kardon Go + Play Wireless system
to turn on the unit.
3. Control music playback through the auxiliary device.
4. Adjust volume using the Volume Up (“+”) and Volume Down (“–”) buttons located on top of
the unit.
Charging Your iPhone/iPod
1. Use the cable that came with your iPad, iPhone or iPod to connect it to the rear USB port
of the Go+Play Wireless. (The rubber landing area on top of your Go+Play Wireless is the
perfect place for resting your iPhone or iPod while charging.)
2. Make sure that the Harman Kardon Go + Play Wireless unit is connected to a live electrical
outlet. Note: The Harman Kardon Go + Play Wireless system will not charge other devices.
3. The Harman Kardon Go + Play Wireless unit will not charge an iPhone/iPod device while
running on battery power.
Technical Specifications
Model:
Harman Kardon Go + Play
™
Wireless
Optional batteries for unit:
8 type D alkaline batteries
Drivers:
Two Ridge and two Atlas transducers
Power:
Tweeters: 2 x 15 watts @ 1% THD
Woofers: 2 x 30 watts @ 1% THD
Frequency response:
40Hz – 20kHz
Input sensitivity (Aux In):
250mV
Bluetooth
transmitter frequency range:
2.4GHz – 2.4835GHz
Bluetooth
transmitter power:
≤20dBm (EIRP)
Bluetooth
transmitter modulation:
GFSK/ /4-DQPSK/8-DPSK
Dimensions:
Length: 20" (500mm)
Width: 9" (230mm)
Height: 9-1/2" (240mm)
Weight:
9.4 lb (4.3kg)
Input impedance:
>10k ohms
Signal-to-noise ratio:
>85dB
External power supply
Input voltage: 100 – 240V AC
Output voltage: 18VDC @ 3.6A
Power consumption:
65W (maximum); 0.5W (standby mode)
HARMAN International hereby declares that this equipment is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC, ErP 2009/125/EC Directive and RoHS 2011/65/EU
Directive. The declaration of conformity may be consulted in the support section of our Web site, accessible
from www.harmankardon.com
