Harman Kardon AVR 510, Owner'S Manual

Page: 34 / 56

34 ADVANCED FEATURES
Advanced Features
the AVR 510 is turned off. Once the unit is
turned off, the semi-OSD displays will remain
activated, even if they were switched off for the
previous listening session.
To change the length of time that the semi-OSD
displays remain on the screen, go to the
ADVANCED SELECT
menu as outlined
earlier, and press the
⁄
/
¤
buttons
n
as
needed, until the on-screen › cursor is next to
the
SEMI OSD TIME OUT
line. Next,
press the ‹
/
› buttons
o
until the
desired time in seconds is displayed. Note that
unlike most of the other options in this menu,
this is a permanent setting change, and the
time-out entry will remain in effect until it is
changed, even when the unit is turned off.
If you wish to make other adjustments, press
the
⁄
/
¤
buttons
n
until the on-screen ›
cursor is next to the desired setting or the
RETURN TO MENU
line and press the Set
button
p
. If you have no other adjustments
to make, press the OSD button
v
to exit the
menu system.
Full-OSD Time-Out Adjustment
The
FULL OSD
menu system is used to sim-
plify the setup and adjustment of the AVR 510,
using a series of on-screen menus. The factory
default setting for these menus leaves them on
the screen for 20 seconds after a period of
inactivity before they disappear from the screen
(Time-Out). Time-Out is a safety measure to
prevent image retention of the menu text in
your monitor or projector, which might happen
if it were left on indefinitely. However, some
viewers may prefer a slightly longer or shorter
period before the Time Out display.
To change the Full-OSD Time-Out, you will need
to make an adjustment in the
ADVANCED
SELECT
menu (Figure 9). To start the
adjustment, press the OSD button
v
to bring
the
MASTER MENU
to the screen. Press
the
¤
button
n
six times, until the on-screen
¤
cursor is next to the
ADVANCED
line.
Press the Set button
p
to enter the
ADVANCED SELECT
Menu (Figure 9).
At the
ADVANCED SELECT
menu
(Figure 9) make certain that the on-screen
›
cursor is next to the
FULL OSD TIME
OUT
line by pressing the
⁄
/
¤
buttons
n
as
needed. Next, press the
‹
/
›
buttons
o
/
until the desired time is displayed in seconds.
Note that unlike most of the other options in
this menu, this is a permanent setting change,
and the Time-Out entry will remain in effect
until it is changed, even if the unit is turned off.
If you wish to make other adjustments, press
the
⁄
/
¤
buttons
n
until the on-screen ›
cursor is next to the desired setting or the
RETURN TO MENU
line and press the Set
button
p
. If you have no other adjustments
to make, press the OSD button
v
to exit the
menu system.
31
31