ADVANCED FEATURES
ADVANCED FEATURES 31
Full-OSD Time-Out Adjustment
The
FULL OSD
menu system is used to simplify
the setup and adjustment of the AVR 230, using a
series of on-screen menus. The factory default setting
for these menus leaves them on the screen for 20
seconds after a period of inactivity before they disap-
pear from the screen (Time-Out). Time-Out is a safety
measure to prevent image retention of the menu text
in your monitor or projector, which might happen if it
were left on indefinitely. However, some viewers may
prefer a slightly longer or shorter period before the
Time-Out display.
To change the full-OSD Time-Out, you will need to
make an adjustment in the
ADVANCED
SELECT
menu (Figure 10). To start the adjust-
ment, press the
OSD Button
v
to bring the
MASTER MENU
to the screen. Press the
¤
Button
n
, until the on-screen
›
cursor is next to
the
ADVANCED
line. Press the
Set Button
p
to enter the
ADVANCED
menu (Figure 10).
At the
ADVANCED SELECT
menu (Figure
10) make certain that the on-screen
›
cursor is next
to the
FULL OSD TIME OUT
line by press-
ing the
⁄
/
¤
Buttons
n
as needed. Next, press
the
‹
/
›
Buttons
o
until the desired time is dis-
played in seconds. Unlike most of the other options in
this menu, this is a permanent setting change, and the
Time-Out entry will remain in effect until it is changed,
even if the unit is turned off.
If you wish to make other adjustments, press the
⁄
/
¤
Buttons
n
until the on-screen
›
cursor is
next to the desired setting or the
RETURN TO
MASTER MENU
line and press the
Set Button
p
. If you have no other adjustments to make, press
the
OSD Button
v
to exit the menu system.
Summary of Contents for AVR 230
Page 50: ...50 NOTES NOTES ...
Page 51: ...NOTES 51 NOTES ...
