CB + Cars can Convert to Fit Old-Style, Non-CB Track
Removing Ball Bearings from CB Cars
Position car on edge and gently push one (1) ball at
a time from center of retaining clip.
Do not remove
retaining clip from car!
Retaining clip
3. Remove retaining clips and corner keepers
over box to catch balls.
Important! Requires CB+ cars. See complete instructions at www.harken.com/manuals.
1.
Use flat-bladed screwdriver to push retaining
clip toward end.
5. Remove two (2) clips from car loader. Slide
car loader in so loading port is on the side
of car without balls.
2. Pry retaining clip off and dump balls in box.
4.
Hold car on edge and load lower side with
correct number of balls.
DO NOT OVERLOAD.
Consult chart to confirm quantity.
6. Put one (1) clip on "open" end of loader.
Load rest of balls through ball loading port
into empty bearing race. Consult chart to
confirm quantity. Line up car loader with
track and gently roll car onto track.
Do not use corner keepers.
Converting CB + Cars to Run on Non-CB Track
CB+ cars designed for CB track.
Order HMR2 car loader.
Track built after 2002. No need to convert car.
Track built before 2002.
Groove for
retaining clip.
CB track
Non-CB track
CB+ cars can convert to run
on old-style, non-CB track.