15
2. WARNINGS
A. Precautions for use.
Do not expose the device to flames, chemicals, damage from falling, extreme temperatures,
dragging or twisting lifelines or ropes on sharp edges, electrical conductivity, cuts, abrasions,
climatic exposure and pendulum falls; risk of hair or clothing entanglement.
B. Working temperatures.
Maximum/minimum working temperature. Humidity and frost can reduce the performance of
the pulley.
C. Inspection.
Before each use, carefully inspect the device for evidence of wear or deformation that could
compromise its proper function.
Inspect and test the proper function of the carabiner and pulley.
If the device shows evidence of wear, damage or inadequate maintenance, it must be
permanently removed from service. Check that it works correctly as described in the USE
chapter.
The frequency of periodic inspections depends on legislation, type of equipment, frequency of
use and environmental conditions.
It is mandatory to carry out a thorough inspection at least every 12 months by an Authorized
Inspector Harken. The Register of Authorized Harken Industrial Product Inspectors it is available
on the website www.harkenindustrial.com.
Do not use SNATCHET devices without having carried out the mandatory periodic inspection.
The inspection must be recorded in the Equipment Record and the inspection report signed by
the Inspector must be kept by the owner of the device.
Regular periodic inspections are necessary procedures for the safety of users because user
safety depends on continuous efficiency and durability of the equipment.
D. Maintenance.
Clean the device by hand in fresh water and allow it to dry naturally keeping it away from direct
heat.
E. Storage.
Do not leave the device exposed to sun, rain or loads for long periods.
Store the device in a dry, ventilated, low-humidity, non-saline environment to avoid corrosion
and protect the product from impacts, chemical agents or possible damage that could shorten
the lifespan or affect the performance of the device. Improper storage can affect the performance
of the device and require it to be removed from service. During storage and transport, use the
original packaging.