34
ENGLISH
01-30-14
PowerSeat PWRS-E
uSInG thE dEvICE - ASCEnt PRoCEduRE 2
1. Install the primary rope on the device as indicated in the “Primary Rope Installation Procedure” paragraph.
2. Wire the Power Supply system as described in the "Wiring the Power Supply System" paragraph.
3. Adjust the position of the accelerator control so it is ergonomically comfortable for the operator as
indicated in the "Adjusting the Accelerator Control Position" paragraph.
4. Supply voltage to the motor by turning on the 48V Power Supply.
5. Operate the device and position it at the height of the operator’s shoulders.
6. Connect the fall arrest device to the harness as described in the “Preparing to Ascent” paragraph.
Upper front
Attachment
to Fall Arrest
Lower Front
Attachment
to PowerSeat
7. Connect the snap-hook supplied with the device to the lower front attachment point of the harness.
In ascent procedure 2 the Waist strop is not used
8. To ascent, push the accelerator lever to the first detent.
WARNING!
Before using the device check that the rope is correctly installed.
WARNING!
Before using the device test the functionallity of the emergency button and the anti-panic system.
Summary of Contents for PowerSeat PWRS-E
