8
Performa
™
Winch
50.2 PTP
Installation and Maintenance Manual - Mod.C
Disassembly procedure
Tools needed
One medium flat-bladed screwdriver
A number five hex key
Rags
To identify the various parts refer to the exploded view at the end of this Manual.
Torque to be applied in assembly phase
Carry out procedure
as shown in the paragraph on winch installation and then do the following:
6. Unscrew the 5 hex screws n°17
( 20Nm/177 in-lb)
7. Remove the assy housing n°16.
Important: washer n°13 may remain
inside the drum support and the
washer n°30 must be replaced in the
correct position.
4. Completely unscrew the three screws n° 26
and remove the sochet support
5. Slide out the central shaft n°20