WARNING! You must mount to solid deck construction using specified fasteners
in all mounting holes and nuts, washers or backing plates to achieve correct
maximum working load to avoid a failure leading to an accident.
Determine if deck is strong enough for mounting the SnubbAir. Make sure all four fasteners are
through bolted using washers or backing plates and nuts. Cored decks must have solid inserts
such as G-10 plates sized to distribute the load. Tapped holes will not work for installing SnubbAir.
Install SnubbAir using sealant in holes. Use supplied washers and nuts or
suitable alternatives.
3
Tip: Put slight bevel at top of hole to allow sealant
to mass around upper part of hole.
Use the mounting template located on page 7 to mark the deck. Note: The studs on the SnubbAir
are integral to the base and are not removable. There are sleeves extending below the base and
these are a larger diameter than the 6 mm threaded studs. Drill holes for 8 mm bosses. See
dimension below.
Drill 8.5 mm or 11/32” holes.
8 mm (5/16”)
6 mm threads
Planning Installation - Deck Strength
Installing SnubbAir