STEP 2
Remove the template from the
area and dig a hole for your liner.
You will want to position the liner
an inch or two higher than the
surrounding ground to prevent
runoff. For softer soil you may
need to dig a 3” deeper hole and
filled to the desired depth with
sand. This will insure a solid
foundation for the liner.
STEP 3
Insert the liner in the hole and use a
level to check that it is level front-to-
back and side-to-side. If it is not
level adjust with sand. When
positioned correctly the top of the
reservoir should be an inch or two
above ground level. (Below ground
level will result in dirty water) Use
removed soil to back-fill and pack
around the liner.
STEP 4
Depending on the installation (number of outlets) build the
pump hose assembly to match the diagram shown.
ONE OUTLET
THREE OUTLETS
TWO OUTLETS
