Hardy Process Solutions HI 6600 Series, Quick Start Manual

Page: 7 / 12

Calibration: Section used to calibrate the instrument to the
sensor(s) used.
C2 eCAL – Electronic Calibration
1) Remove all weight from the scale.
2) Set gravity correction for location of weighing system
3) Press Do C2 Cal.
4) Place a verification weight on the scale to ensure calibration is
successful.
Hard Cal ‐ Traditional Calibration
1) Input the Span Weight. The span weight should be about 80%
of the scale capacity.
2) Input Cal Low Weight . With nothing on the scale, the Cal Low
Weight is 0, with 5 lbs on the scale, the Cal Low Weight would
be 5.
3) Press Do Cal Low to set the low point on the calibration curve.
4) Place the Span Weight onto the scale.
5) Press Do Cal Hi.
Refer to User’s Guide if adjustments to other calibration ‐ related
parameters are required.
Communication: Section used for setting up communications to
the instrument.
Ethernet TCP/IP
1) Connect an Ethernet cable between the instrument’s RJ45
connector and a PC, then power up the instrument. A cross ‐
over cable is not required, but can be used.
2) The instrument will auto ‐ negotiate settings suitable for a variety
of operating systems and network configurations. Wait
approximately 15 seconds and check to see if the green light of
the Ethernet port is on and blinking – if so, skip to step 8 – you
are connected.
3) If the green light on the Ethernet port does not light up, check
that the unit’s Enable DHCP is turned off and follow steps 4
through 9.