Hardy Process Solutions HI 2160RC PLUS, Operation And Installation Manual

Page: 53 / 220

HI 2160RC
PLUS
MANUAL
4-4
information. (See Fig. 4-6 for jumper locations) Both outputs are avail-
able simultaneously. The four potentiometers are used to adjust the
Zero and Span for both the current and voltage outputs. (See Fig. 4-6
for their locations.)
CAUTION WHEN OPENING THE BACK OF THE HI 2160RC PLUS, MAKE SURE
THAT YOU USE PROPER ELECTROSTATIC DISCHARGE PROCEDURES
TO PREVENT DAMAGE TO THE INSTRUMENT.
Setting the Jumpers
Setting The
Jumpers in the HI
2160
PLUS
Step 1. Disconnect the power cord.
Step 2. Use a phillips screw driver and remove the two (2) pan head
machine screws that fasten the rear panel to the extrusion.
(See Fig. 4-3)
Step 3. Gently pull out the rear panel with the top and bottom panel
and printed circuit boards attached.
Step 4. Remove the two (2) pan head machine screws that attach the
top panel to the rear panel. (See Fig. 4-4)
Step 5. On the Analog Output Card, set the jumper that matches the
system's feedback voltage or current configuration. (See Table
4-2)
Step 6. Attach the top panel to the rear panel by replacing the two (2)
pan head screws.
Step 7. Gently slide the rear panel back into the extrusion.
Step 8. Replace the pan head machine screws that attach the rear
panel to the extrusion.
Step 9. Connect the power cord.
Phillips Pan
Head Screws