STEP 8 - Secure Self-Adjusting
Bracket and Install Cans
Once door is installed and aligned, cycle the unit a couple of times
making sure the soft-close is working correctly. Then open the
unit all the way and install into the center of each of the self-
adjusting rear brackets one (1) #8 x 1/2” Pan Head Phillips Wood
Screw to hold the bracket in place. Install trash cans.
STEP 5 -
Install Pullout Unit
STEP 6 -
Install Door
STEP 7 -
Door Mounting Adjustments
Install the Final Assembly into the cabinet by aligning the
slides and pressing the unit into the cabinet until the soft-close
mechanism engages.
Loosen the door mounting set screws and slide bracket out to desired
position to attach to the door rail. Measure from the center of the slot
on the door mounting bracket to the estimated top of door. Mark door
with measurement for both top brackets. Install door with the four (4)
#8 x 5/8 Flat Head Phillips Wood Screws provided. (NOTE: DETERMINE
CORRECT SCREW LENGTH TO DOOR PANEL THICKNESS.) Double sided
tape included with hardware to assist with door installation.
To adjust door up or down loosen door mounting screws (A).
To adjust left or right, loosen both set screws (B) adjust and
retighten. To adjust tilt, loosen both set screws (B) and then
turn tilt screw (C) clockwise to desired distance and then
retighten set screws.
CANTMDSC12/17 v.1
Face frame
Door frame
Center of
mounting
bracket slot
to estimated
top of door
B
A
C
Tilt adjustment (up to + 1/4”)
Left/Right adjustment (+/- 7/8”)
Full extension (+2-1/2”)
Up/Down adjustment (+/- 1/4”)
Door mounting
set screws
