Hardt Inferno GC, Operation Manual

Page: 14 / 18

HARDT
Responsive, Reliable Solutions
Page 14 of 18 CUS-013-0025-02
5.1.3 Cleaning at the End of the Day: AutoClean Operation
It is recommended to run the AutoClean cycle at the end of the business day, after all cooking has been
completed.
Description of the AutoClean Operation
The AutoClean cycle consists of a succession of activities that are completely and automatically controlled by
the rotisserie. The sequence is as follows:

OVEN COOLDOWN: A period of time required for the rotisserie to reach a safe temperature for cleaning.

PREWASH: Fresh water is used for an initial flush of the drip pan.

SOAP WASH: involves the repeated application of a cleaning agent followed by soaking and draining.

FIRST RINSE: a rinsing cycle.

POWER RINSE: another, different type of rinsing cycle.

FINAL RINSE: a series of rinsing cycles involving water collection followed by draining.
Instructions for AutoClean
1. Verify that there is sufficient degreaser in the bottle to run
an AutoClean cycle. If the level is too low, replace the
bottle.
2. Open the door to the rotisserie.
3. Remove any large pieces that are left on the bottom of the
drip pan.
4. Using a wet towel, clean the front channel, exterior panel
and the inside door glass pane.
5. Rotate the Main Drain Valve Handle to CLEAN as shown
in Figure 5-1.
6. Close the rotisserie door and press CLEAN and then
ENTER to start the cleaning cycle. Read the display. If
the AutoClean has begun it will read either,
“CHECKING
OVEN TEMPERATURE”
,
“CLEAN COOLDOWN”
or
“PREWASH”
.
Figure 5-1
If the display reads,
“CLEAN COOLDOWN”
the AutoClean will not start immediately as the cooking cavity
is too hot. DO NOT open the door to cool the rotisserie! It must cool on its own with the door closed
for optimal AutoClean performance and to avoid damaging the inside of the oven.
The AutoClean will start on its own when the unit has properly cooled.
For units equipped with the optional sensors
– If the degreaser is low, an alarm will sound and the display will
show:
“REFILL DEGREASER BOTTLE // PRESS CLEAN”
. Replace the degreaser bottle and start again.
If the display shows:
“CLOSE DRAIN VALVE // PRESS CLEAN”
, the Drain Valve is not fully closed. Close it and
start again.
7. Clean the outside of the rotisserie following the convections outlined in 5.3 Material Cleaning Guidelines.