?
or damage?
6.Battery level display.
Battery level is displayed as below
：
When the battery voltage is empty, it will flash to remind you to change the battery.
Specification-----1 magic tape-----1 zip tie-----2 temperature sensor
-----(two kinds
R
ing
terminal end
(NTC)
)
PT100 temperature range
Temperature accuracy
Refresh rate
Canning material
Waterproof
Display mode
Display window size
（
visible
）
The temperature sensor line length
Product weight
Product size
Battery specificaion
-20 - +300
℃
(
-4-+572
℉)
±
1%
℃(℉)
6s
ABS
IP65
22mm×44mm LCD
18mm*42mm
60cm
84g
67mm×35mm×17mm
CR2032 210mAH
Problems
Possible reason
Solution
The window screen no
display
2.The battery installation is wrong.
1.Is the battery empty .
2.Check if the battery
installation is
1.Replace a new battery.
LCD screen display err
1.Sensor is not installed in the right way.
2.Sensor is damaged.
1.Reinstall the sensor
2.Change the new sensor
.
.
Display no change
Disturbed crash.
Install the batteries again.
LCD screen display is not
clear or discoloraton
1.Angle wrong.
2.Lack of battery.
1.Adjust angle
2.Replace battery
.
.
After setting, press the MENU button and SET button together more than 2 seconds, then confirm and exit the setting interface.
When the product is working ,if the instant temperature is higher than the temperature reminder value, the warning
3.Reset the maximum temperature.
In the maximum temperature interface,press the MENU button
2 seconds, the current max temperature value will
the reset value is - 20
℃
(-4
℉).
more than
be reset,
4.Set the temperature unit.
In view of the temperature unit interface, long press the MENU button
2 seconds,then enter into the
interface,the temperature unit symbol will flash.The default of temperature unit is "c".
more than
temperature unit setting
After entering the setting interface, short press the SET button or MENU button to select the temperature unit (
℃
or
℉).
After setting, long press the MENU button and SET button together
2 seconds, then confirm and exit the setting
more than
【
Notice
】
:
After switching the temperature unit, the original temperature reminder value will have a small changes.
7.When the product is in any working condition, such as in setting interface or view
if there is without any operation
switch to the instant temperature display interface automatically.
interface,
more than 10 seconds,it will
3
4
1
2
3
1
2
Product parts list
4
Product Technical Parameters
5
Troubleshooting
6
5
.
Sensor type selection
.
In view of the sensor type interface,long press the MENU button more than 2 seconds,then enter into the sensor type selection
After entering the setting interface,short press the SET button or MENU button to select the sensor type(NTC or PT100).
1
2
3
NTC temperature range
-
20
℃
-
+150
℃
(-4-+302
)
℉
signs will flash in the instant temperature interface.
After setting,long press the MENU button and SET button together more than 2 seconds,then confirm and exit the setting
interface,the current sensor type is flashing.The default of the sensor type is NTC.
interface.
Radiator wedge
correct or not.
interface.
