ASSEMBLY INSTRUCTIONS CONTINUED
3. Next, Insert the slide rods into the two side rails. Squeeze the Johns Hopkins handles or
the
fi
ngertip trigger mechanism to allow the slide rod to go down into the rail on each side
and lock it into place in the top position as shown below.
4. Take the side curtain assembly next. While squeezing the
fi
ngertip mechanisms to
disengage the lift bar trigger assemblies, thread the lift bar onto the slide rods from the top
through the white plastic lift bar glides at either end of the lift bar. slide the fabric loops onto
the slide rods. (Do not put the top curtain rod on at this time.)
At the top of both slide rods, place a white metal stop ring approximately 1-1 1/2” from the
top of the slide rod (the stop ring can be placed over the top most notch in the slide rods),
and fasten with an Allen Key. Do not fasten too tightly as they may need to be adjusted
once the crib is assemblied. See close up photo on next page for reference.
Now place the top curtain rod over the two slide rods to rest on the stop ring. Squeeze
fi
ngertip release mechanisms and lower the curtain lift bar until it locks into place just above
the side rail. Assembly of the sides is complete.
Johns Hopkins Handle
Lift Bar Glide
Lift Bar
Fingertip Trigger
Mechanism
Top Curtain Rod
Slide Rod
