EN
22
4�
Mark out the attachment points and pre-drill if necessary� Screw the brackets on the walls with suitable screws for the wall material�
5�
Put the pins in the attachment points and tighten the tensioners clockwise� Tighten both tensions on each side of the gate at the same
time�
NOTE:
The gap between the gate frame and gate leaf disappears after the tensioners are correctly adjusted�
6�
Tighten the tensioners until the top lock and the top right corner piece are in line� The gap between the top lock and the top right corner
piece should be 1 mm�
7�
Centre the gate in the opening� The gap between the walls and tensioners at the bottom of the gate should be the same on both sides�
8�
Check that the gate is firmly attached at the top and bottom�
1 mm
