EN
15
3. Enter the code 8888 on the code lock
panel and then press A or B twice "•"
flashes several times, after which "H"
is shown. The garage door opener has
learned the keypad code on position A
or B.
FIG. 3
NOTE:
Repeat the above steps if more keypads are
to be learned.
The gate opener can learn 2 keypads.
REMOVE PAIRING
1. Press LEARN until "•" is replaced by "H".
Pairing between the garage door opener
and the code lock has been removed.
FIG. 4
NOTE:
This method also removes the pairing
between the garage door opener and remote
controls.
DELETE PIN TO CODE LOCK
1. Press button A and B at the same time on
the code lock panel.
2. The code lock bleeps for 5 seconds, which
indicates that the PIN has been deleted.
PROGRAM NEW PIN FOR CODE
LOCK
1. Press button A, enter a four digit PIN,
press button A, and enter the same four
digit PIN again.
2. The code lock bleeps twice and the status
light flashes twice, which indicates that
the new PIN code has been received.
CHANGE PIN
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Battery (included)
2x 1.5 V AAA
Size
92 x 75.9 x 32.7 mm
Protection rating
IP44
Frequency
433.92 MHz
Current on standby
2 μA
Active current
14 mA
Frequency band
UHF (ultrahigh frequency)
DESCRIPTION
This wireless keypad has backlit buttons and
is intended to operate garage door opener
018980.
NOTE:
Read the instructions for 018980 as well.
USE
PAIR THE REMOTE CONTROL WITH
THE GARAGE DOOR OPENER
1. Plug in the plug. "H" flashes on the
display and the light goes on. The unit is
in standby mode.
FIG. 1
2. Press the LEARN button on the garage
door opener for at least 2 seconds. "•" is
shown on the display.
FIG. 2
Summary of Contents for 018983
Page 4: ...3 4 5 1 2 ...
Page 5: ...6 ...