Page 11
For technical questions, please call 1-888-866-5797.
Item 57383
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
General instructions for use
1. Make sure that the Trigger is in the
off-position, then attach the Battery Pack.
2. Make sure that the Battery Pack clicks into
place securely. Be sure the Battery Pack
is securely seated into the Drill Handle
so it does not fall off during use.
3. Slide the Direction Switch (which should initially
be centered in the “lock” position) to the right for
forward drilling/fastening, or to the left for reversing
the operation. Use the “reverse” setting only to
remove screws or to release jammed drill bit.
WarninG!
Most drill bits are designed for use in
the forward, clockwise direction. Do not use a drill
bit in the opposite direction than it is designed for.
4.
WarninG! tO prEVEnt SEriOuS inJury:
Do not change direction of rotation while
chuck is rotating.
Wait until Chuck has come
to a complete stop before changing direction.
5. If using the Drill to insert or remove screws, position
the driver tip in the screw to insert or remove.
6. If drilling a hole, hold the Drill above the area to drill.
7. Press the Trigger to start the drill. The Work
Light will also activate once the Switch is
pressed and turn off once Switch is released.
8. When inserting or removing a screw or bolt, use
slight pressure at first to keep the screw driver bit in
the head of the screw or bolt and cause the screw
or bolt to thread into or unthread from the material.
9. When drilling a hole, let the Drill do the work,
using only enough pressure to follow the
drill as it cuts the hole in the material.
cautiOn!
The tool will restart automatically if stalled.
10. When finished using the Drill, release the
Trigger and center the Direction Switch to lock
the trigger mechanism as a safety measure.
11. To prevent accidents, turn off the tool and
remove its Battery Pack after use. Clean, then
store the tool indoors out of children’s reach.
