Page 9
For technical questions, please call 1-888-866-5797.
ITEM 59206
SAFETY
SETU
p
Op
ERA
TION
M
AINTENANCE
Initial Tool Set Up/Assembly
Read the ENTIRE IMpORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURY:
Operate only with proper spark arrestor installed.
Operation of this equipment may create sparks that can start fires around dry vegetation.
A spark arrestor may be required. The operator should contact local fire agencies
for laws or regulations relating to fire prevention requirements.
At high altitudes, the engine’s carburetor, governor, and any other parts that control the fuel-
air ratio will need to be adjusted by a qualified mechanic to allow efficient high-altitude use
and to prevent damage to the engine and any other devices used with this product.
Note:
For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
NOTICE:
This Generator is not intended to power sensitive electronic equipment without the addition of an
appropriate line conditioner and surge protector (both not included).
Sensitive electronic equipment includes,
but is not limited to, audio/video equipment, some television sets, computers, and printers.
Sensitive
electronic equipment should be operated on approved inverter-type generators or pure sine wave generators.
Note:
Wheel Kit, #64788 (sold separately) can be used with this Generator.
Battery Setup Instructions
All generators can be started using the recoil method. This Generator requires installation of a
battery to operate the electric start feature. Connect the battery to the Generator engine:
1. Place a fully charged, lead-acid 12 V battery (not included) in the battery holder on the Generator.
2. Bolt in place using the hardware included with the Generator.
3. Attach the positive (red) cable connector from the engine
to the Positive Terminal on the battery. Connect cable
securely to prevent disconnection and short circuits.
4. Attach the negative (black) cable connector to the negative battery terminal.
Note:
Use 12V, 9Ah minimum sealed Lead-Acid Battery only. Thunderbolt
Battery #62586 (sold separately) can be used with this generator.
Positive
Connector
Negative
Connector
Hardware
Battery
