#04819
Page 4
Step 2)
Insert Steel Tube (#2) into the hole in one Plastic Joint (#1), then into the hole
directly across on the second Plastic Joint (#1). Repeat for the remaining two (2)
Steel Tubes (#2) and other two holes in each Plastic Joint (#1)-see Figure 1 and
Assembly Diagram Step 1.
Step 3)
Repeat Step 1 and Step 2 for each of the remaining four (4) shelf assemblies.
Step 4)
Insert one Vertical Tube (#4) into hole in each corner of Plastic Joint (#1). Place
completed shelf assembly (see Steps 1, 2 and 3) with Plastic Joints (#1) onto Vertical
Tube (#4).
Step 5)
Repeat Step 4 until all four shelf assemblies are in place-see Figure 2 on page 4.
Step 6)
Once you have used all 16 Vertical Tubes (#4) and completed shelf assembly,
insert the ends of one Top Tube (#5) into both Plastic Joints at top of Greenhouse-
see Figure 3. Repeat for 2nd Top Tube (#5).
Step 7)
Place Wire Shelves (#6) on each of the bottom 3 shelf assemblies. Place Half Wire
Shelf (#7) on fourth level shelf assembly.
Step 8)
Place Polypropylene Cover (#8) over entire steel assembly. Wrap the Velcro straps at
the bottom around the Vertical Tubes on each side of Greenhouse to secure in place.
The front opening can be unzipped, rolled up and tied at the top to maintain an
opening in the Greenhouse to provide ventilation and access to shelves.
Unpacking
When unpacking your Mini-Cold Frame Greenhouse, check to make sure the following parts are
included. If any parts are missing or broken, please call
HARBOR FREIGHT TOOLS
at
1-800-444-3353.
Parts List
Part #
Description
Quantity Part #
Description
Quantity
1
Plastic Joint
10
5
Top Tube
2
2
Steel Tube
15
6
Wire Shelf
3
3
Steel Tube
5
7
Half Wire Shelf
1
4
Vertical Tube
16
8
Polypropylene Cover
1
Note: Some parts are listed and shown for illustration purposes only and are not available
individually as replacement parts.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL
AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY
REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO
MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS
OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT
ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LI-
CENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY
ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
Brought to You by Augusta Flint
