Page 9
For technical questions, please call 1-888-866-5797.
Item 61796
Changing the Light Bulb
1. Unplug Power Cord from outlet.
2. Let Bulb cool for 10 minutes.
3. Open the Lamp Replacement Door on the rear of
the Heater by removing the Screws. See Figure C.
Bulb
Lamp Replacement Door
Screw (42)
Figure C
4. Replace the Bulb with a new bulb described
under
Specifications
section on page 2.
WARNING! TO PREVENT SERIOUS INJURY:
Do not use a different type of light bulb or one
with output greater than 40 watts to prevent fire.
5. Reattach Lamp Replacement Door with Screws.
WARNING!
TO PREVENT SERIOUS INJURY:
Do not operate this heater without the access
panel in place. Do not remove back cover.
Troubleshooting
If the heater does not operate:
a. Make sure that the heater is plugged in.
b. Ensure that the outlet used is powered and
that the circuit breaker is not tripped.
c. Avoid the use of an extension cord. However,
if you have to use an extension cord, the
cord shall be No. 16 AWG minimum size
and rated not less than 1500 watts.
d. Check for any obstruction in the heater’s vents.
If an obstruction is found, unplug the
heater and wait for it to cool completely.
Then, carefully remove the obstruction.
e. Make sure the heater is placed on an even
surface. Uneven surfaces may activate the
heater’s tip-over switch, which turns the heater off.
If the above remedies do not solve the problem,
take the heater to a qualified service technician
for diagnosis and repair.
